Here is some of the stuff
you will need to crank out a supply of vehicles. (or any other small details you
want)
On this project I will
describe the materials I used in each step.
The vehicles in the box
were made using Envirotex Lite for clear and Micro-Mark
CR-300 for the white castings. I am trying out the new CR-600 casting resin
because it has a slower cure time...30 minutes instead of 3 to 4 minutes for the
older CR-300 resin.
I used Mold Builder
latex rubber to make the mold because it is easier to make sure there are no
bubbles. You can get the Mold Builder and Envirotex Lite from your local craft
store, but you have to order the CR-300 and CR-600 from Micro-Mark.
Click on
the photo to advance to the next page
